Search

ANSJ-APT8S2M

ANSJ-APT8S2M

  • 8X10/100/1000 MBPS PORT SUPPORT POE 3AF/AT STANDRAD
  • SUPPORT UPLINK PORT 2×10/100/1000MBPS SFP
  • SUPPORT 1 CONSOLE PORT TO CONFIGURE SWITCH DIRECTLT BY
  • SUPPORT TOTAL POWER BUDGET MAXIMUM 120
  • SUPPORT SINGLE PORT OUTPUT MAXIMUM
  • SUPPORT BACKPLANE BANDWIDTH SPEED 20GBPS
  • HIGH PERFORMANCE CHIPSET, NO LAG
  • WEB MANAGMENT LAYER-2
  • 100–240VAC VOLTAGE RANGE
  • LIGHTINING PROTECTION UPTO 6
  • PLUG-N-PLUG FOR EASY TO
  • FANLESS LOW HEAT
Indoor Air Quality Monitoring Motion Detection Water Leak Detection Distance Detection License Plate Recognition
Indoor Air Quality Monitoring Motion Detection Water Leak Detection Distance Detection License Plate Recognition
Hardware Specification
 

Network Ports

8×10/100/1000Mbps RJ45 PoE+ Port
2×10/100/1000Mbps SFP Port
1xConsole Port
Network Protocol Standard IEEE 802.3, IEEE 802.3u, IEEE 802.3x, IEEE 802.3af, IEEE 802.at, CSMA/CD, TCP/IP
Single Port Output Up to 30Watt Max
PoE Power Budget 120 Watt
CCTV Extend Mode N/A
VLAN Mode Supported
Backplane Bandwidth 20Gbps
Packet Forwarding rate 14.88Mpps
 

Forwarding Rate

10Base-T: 14880PPS
100Base-T: 148800PPS/port
1000BASE-T:1488000PPS/port
MAC Address MAC address table 8K
Package Cache 4MB
Jumbo frame 9.6kbytes
Port Function Power, SYS, Link/Act:10/100/1000Mbps, POE+
LED Indicator PoE Status indicator, whole power indicator
Power Input Single, AC 100~240V, 50/60 Hz
Operating Temperature -20°C ~ 55°C
Operating humidity 95% maximum relative humidity, non-condensing
Lightning Protection 6KV
Weight 1kg
Casing Metal
Dimension 202mm x 140mm x 45mm
Software Specification
 

 

Port Management

Enable/Disable port
Speed, duplex, MTU setting
Flow-control setting
Port information view
Port Mirroring Support port and aggregation group access direction
Port Speed Limiting Support port speed limit, the granularity of the speed limit is determined by the chip
Port Isolation Support port isolation setting
Storm control Support location unicast, unknown multicast, broadcast storm control

 

Link Aggregation Support static manual aggregation, support VLACP dynamic aggregation
 

 

VLAN

Access/Trunk/Hybrid
Support VLAN division based on port, protocol and MAC, support QINQ
Support GVRP dynamic VLAN registration
Voice VLAN (support required)
 

MAC

Support static add and delete
MAC address learning quantity limit
Support dynamic aging time setting
 

Spanning Tree

Support 802.1d(STP)
Support IGMP-snooping
Support 802.1S(MSTP)
 

 

Multicasting

Support static add and delete
Support IGMP-snooping
Support IGMP-snooping
Support V1/2/3 dynamic multicast snooping
DDM Support SFP/SFP+DDM
 

 

 

ACL

Based on source MAC
Destination MAC
Protocol type
Source IP
Destination IP
L4 Port Number
 

 

 

 

Qos

Classification based on 802.1P (COS)
Classification based on DSCP
Classification based on source IP
destination IP
port number
support for SP
WRR scheduling policies
Support traffic speed limit CAR
LLDP Support LLDP link discovery protocol
User Setting Add/Remove Users
Log User login, operation, status, event record log
Anti-attack DOS Defense Support for CPU protection
limiting the rate of upgoing CPU messages ARP binding (IP, MAC, PORT binding)
Network Diagnosis Support ping, Telnet, Trace
System Administration Device reset, configuration save/revert, upgrade management, time setting, etc.
CLI Support serial port command line management
Telnet Support telnet remote management
SSH Support SSHV1/2 remote management
SNMP Support V1/2/3 Support trap: cold start, warm start ,link down, link up
Web Support two levels of settings, two or three levels of view
RMON Support RMONV1
POE Configuration PoE configuration, PoE scheduling management, etc.
Countries
Covered
0 +
Successful Implementations
0 +
Satisfied
Clients
0 +
Customer Satisfaction
0 %